After click "Buy Now", the item are placed in PRIVATE WAREHOUSE.

Description

This is a tool for use in model assembly.

TSD00380 Concave Edge Sharper [B]

Material: 0.2mm thick SUS/PE

This is a sharper with the blade of the "Concave Edge Sharper" reversed.
It can be used for evenly carving long curves and similar tasks.

A cutting tool designed for engraving recessed, gentle valleys such as figure eyelines, hair valley lines, and clothing wrinkles.
The uneven surfaces on the front and sides of the sharper allow you to carve intersecting two surfaces simultaneously.
The "front blade" has a width of 0.4mm, and the "back blade" has a width of 0.2mm.
Use each side according to the part you are working on.

If blade flex ("springiness") is a concern, incorporate it into a design knife holder together with the support.

Two supports are included.

No adhesive is required for assembly and reconfiguration, but use glue if additional strength is needed.

It is recommended to protect the surrounding area of the part with masking tape or similar when in use.

Be especially careful not to scratch the part surface with the support.