After click "Buy Now", the item are placed in PRIVATE WAREHOUSE.

Description

This is a sheet of water-slide decals for marking car models.

A small sheet of Marlboro decals to supplement the decals in Tamiya's 1/12 McLaren MP 4/6 kit, which does not include the original tobacco markings due to licensing restrictions. (they are replaced with similar-looking "McLaren" markings in the kit).
How to use Studio 27's Hi-Tech decals:

These decals are recommended for moderate to experienced modelers as they are more difficult to work with than standard-type decals.

(1) Make sure the surface to which the decal is to be applied is free of fingerprints or other oils. The surface should be as smooth as possible.

(2) Cut out the decal to be applied using scissors or a hobby knife.

(3) Soak the decal in lukewarm water. Remove it from the water as soon as the decal can slide around on the backing.

(4) Carefully slide the decal off the backing paper and onto the surface to which it is to be applied.

(5) After positioning the decal, use a tissue or other soft cloth to push all air out from under the decals, beginning in the center and working your way out to the edges.

(6) Allow the decal to air dry for at least one day. Drying time is affected by the season.

(7) After the decal is thoroughly dried, use cellophane tape, etc., to remove the clear covering from the decal. Work slowly to avoid any of the coloring from the decal being pulled off with the clear covering.

(8) If any adhesive remains on the surface of the decal after removing the clear covering, use a slightly damped cloth or tissue to blot off any residue.